USING OF CFD AS A TOOL FOR ANALYSIS OF CFBC BOILER USED IN THERMAL POWER PLANTS

Md Shariq Ahmed, Peram Kondala Rao

Abstract


Heavy modernization & reworking of club demands in developing of prestige make to scrutinize & intensify new robotics & potent discharge of current management units. A variety of sources is handy for sovereignty breed being traditional sources like thermic, hydro, biological and continual sources like wind, falling, biomass get snug & stellar. Out of the above-mentioned most popular & reasonable way for bringing forth the sovereignty, are by sizzling strength stations. Various technical boilers play a decisive role to unconditional the sovereignty time rhythm being CFBC, FBC, AFBC, CO Boiler, RG & WHIR Boiler (Waste heat renewal Boiler). This essay is calculated to meticulously broadcast grasp associated to stiff & its bankruptcy in CFBC kiln with the due fact of flue gas flow at the same time as surgery on a firm by adopting current mechanization of CAD & CAE. By unapplied letter of the particular robotics quite escalate wear manage to figure out in respects the flow of flue gas & bed object flow indoors the CFBC loop via CFD (Computational Fluid Dynamics) operating system. The results obtained are favourable to discern the strike of gas & particles on contrary taciturn areas & also maintained to love correct will full text unflappable regions.


Keywords


CFD Simulation; Cyclone Separator; CFBC Loop; Refractory For CFBC Boiler; CFBC Boiler;

References


R&D in perfect strength technologies, Report CB011, DTI Publication, UK 2001.

Fluidized bed oxidization technique for management period and alternative mechanical form, robotics quality word 011, DTI Publication, UK 2000.

Balagurunathan S. Technical demonstration on moving fluidized bed turmoil kilns on nuclear power plant technique and equipment, HRDC training lecture, BHEL text, Hyd, 2001.

Voyles R. Gagliardi C, Wolfson D. Design difficulty for a 250 MW CFB, ASME 13th association on FBC, Vol 2, 1995, pp. 703-711.

Abduallaly IF, Reed K. Experience of firing deplete fuels in faster wheelers in motion fluidized kiln, ASME 13th forum on FBC, vol 2, 1995, pp. 753-765.

Basu P. Boiler and burners, Vol 11, New York, Springer 2000, pp. 320-329.

G. B. Malone, the Computational opinion of unimportant air flow in the wall smoking power source, Ph. D. memoir, Tennessee Technological University, 2002.

Masoud Rahimi, Abbas Khoshhal, Seyed Mehdi Shariati, CFD modeling of stove tube rapture, Applied snug metallurgy, vol 26, 2006, pp. 2192-2200.


Full Text: PDF

Refbacks

  • There are currently no refbacks.


Bookmark and Share


Copyright © 2012 - 2023, All rights reserved.| ijitr.com

Creative Commons License
International Journal of Innovative Technology and Research is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJITR , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.