PRACTICAL INVESTIGATION ON MRR IN WIRE CUT EDM FOR OBSERVE THE PARAMETERS EFFECT ON SURFACE QUALITY

A Praveena, K Kiran Kumar, Faiz Ali

Abstract


The aim of the triumphing artwork is to investigate the results of the numerous Wirecut EDM technique parameters at the surface quality, maximum cloth elimination rates and collect the greatest sets of method parameters in order that the nice and MRR of machined additives can be optimized. Experiments could be performed on the portions thru parameters. Wire Cut Electric Discharge Machining technique with a skinny wire as an electrode transforms electric powered powered electricity into thermal energy for slicing substances. WEDM is considered as a very unique adoption of the traditional EDM manner, which makes use of an electrode to initialize the sparking manner. However, WEDM utilizes a constantly touring cord electrode made from skinny copper, brass or tungsten of diameter zero.05-zero.30 mm, this is able to reaching very small nook radii. The wire is stored in tension the usage of a mechanical tensioning device reducing the tendency of manufacturing defective factors. During the WEDM technique, the fabric is eroded earlier of the twine and there's no direct contact among the workpiece and the twine, eliminating the mechanical stresses all through machining.


References


Evaluation of Optimal Parameters for machining with Wire reduces EDM Using Grey-Taguchi Method through S V Subrahmanyam, M. M. M. Sarcar.

Performance Analysis of Wire Electric Discharge Machining (WEDM) with the resource of Atul Kumar, DR.D.K.Singh.

Analysis of Process Parameters in Wire EDM with Stainless Steel Using Single Objective Taguchi Method and Multi-Objective Grey Relational Grade thru M. Durairaja, D. Sudharsunb, N. Swaminathan.

Optimization of device parameters of micro wire EDM with the beneficial useful resource of Ricky Agarwal.

A Study to Achieve a Fine Surface Finish in Wire-EDM with the beneficial useful resource of manner of J.T. Huang, Y.S. Liao, and Y.H. Chen.

Rajurkar K.P., Scott D, Boyina S., “Analysis and Optimization of Parameter Combination in Wire Electrical Discharge Machining”, International Journal of Production Research, Vol. 29, No. Eleven, 1991, PP 2189- 2207.

Y. S. Tarng., Ma S.C., Chung L.K., “Determination of Optimal Cutting Parameters in Wire Electrical Discharge Machining”, International Journal of Machine Tools and Manufacture, Vol. 35, No. 12, 1995, PP. 1693-1701.


Full Text: PDF

Refbacks

  • There are currently no refbacks.




Copyright © 2012 - 2021, All rights reserved.| ijitr.com

Creative Commons License
International Journal of Innovative Technology and Research is licensed under a Creative Commons Attribution 3.0 Unported License.Based on a work at IJITR , Permissions beyond the scope of this license may be available at http://creativecommons.org/licenses/by/3.0/deed.en_GB.